I just finished converting my new Chimera, It was a rather easy build!
Step one:
Build the tracks as normal, Cut out the wheels, glue them to the frame, place the tracks into place. This will give you an easier time with the next few steps, to help with the foundation.
Step two:
Take the top of the Chimera, the part where the turret will be place on, and cut at the end of the second hole (Towards the back) then cut before the first hole so that you have three pieces, one is the front where the turret will go to. Next is a piece with two holes in it, and the last is the last hole, and where the loading dock goes.
Step Three:
Smooth out the pieces, place them upside down and glue them into place, make sure there is a tight bond between them, when it is dry use some green stuff to make a very strong bond!
Step Four:
Glue the front of the chassis onto the bottom of the tank, then take the piece from step three and glue it slightly behind the whole on the first one front of the tank! Make sure everything is snug!
Step Five: Glue the tracks to the chassis, then you have your foundation! After that you are all set to go!
Step Six: Glue pieces where you see fit, and clean it up a little bit!
Final product should look something like this!
Hope this helps everyone out there a little bit, pics will come when I get another one, so hold in there tight comment if you have any questions!
Ace
No comments:
Post a Comment